Yale HSA3000 Specifiche Scaricare il pdf (Pagina 5)

Programming the Siren-based system

(without control panel)

The siren is the heart of the system. All components must be recognised by the siren.

This unit is equipped with the latest type of

radio receiver using FM radio technology. If the

system is armed any criminal attempt to interfere

detector transmissions will trigger an alarm.

If the alarm is frequently triggered by interference

there may be high levels of unusual radio signals

in your area. Some kinds of electronic equipment

can generate this kind of radio interference.

In the unlikely event of you experiencing problems

with interference, it is recommended that you

switch interference detection off.

SETTING

Enable/disable Jamming & interference

detection:

• Set Dip switch 2 for interference detection. Switch

On to enable and Off to disable (recommended

default).

The system is now ready for wall mounting.

WARNING

The siren is very loud, be prepared! Take care not

to activate the siren tamper switch unnecessarily.

Switch the siren’s power switch to ON

(The LEDs will now ﬂash with one short beep.)

Once powered, the siren will enter learn

mode for 3 hours. All tamper protections

are disabled within this time period. Please

ensure that ALL devices are ﬁtted before

this mode expires.

The system is pre-learnt in the factory and the

system should recognised all the items (within

this kit) as default.

If the items are not recognised, deleted by

accident or purchased accessories, please press

learnt/action buttons on the accessories (when

the power switch is ﬁrst turned on and under

learn mode) to learn each one into the system.

Do not press the siren learn button. See Chapter

2 for learn button location. The siren will beep

each time it receives a learnt signal.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Nessun commento

Yale HSA3000 Specifiche Pagina 5