Yale SmartHome Alarm series Specifiche Scaricare il pdf (Pagina 21)

Using your keypad

•ThekeypadcanbeusedtoAwayArmandHome

Arm the system using the buttons as shown.

•Thesystemisdisarmedbypressingthedisarm

button followed by any user code, similar to using

the control unit keypad.

•Anemergencyalarmcanbeactivatedbypressing

the panic A and B buttons simultaneously.

Deactivate you panic event by pressing disarm

button followed by any user code.

•Thekeypadusesthesameuserpincodes

programmed into the control unit for disarming.

•Toextendtheexittime,pressthearmorhome

arm button once more on the keypad.

•Ifthereisasystemfault.youwillneedtopressthe

arm/home arm button for a second time to “force

arm” the system.

Using your smoke detector

Smoke Detection

When smoke is detected the device will activate for

a minimum of 10 seconds with a two tone alarm and

ﬂashing LED for a local ﬁre alarm. The detector will

send a radio signal to the control unit for activating a

system ﬁre alarm.

•Pressingthetestbuttonwheninanalarm

condition will silence the alarm for 10 minutes. It

will automatically resume smoke detection again

after this period.

•Ifthesmokedensityisstilloverthealarm

threshold, then the smoke detector will remain in

an alarm condition and it will repeat the local ﬁre

alarm with a radio ﬁre alarm signal to the control

unit.

Testing

•Smokedetectortestingshouldbedoneona

regular monthly basis. Pressing the test button will

make the LED ﬂash, the audible sounder chime

and will send a radio test signal to the control unit

when the button is released. If nothing happens

after pressing the test button, it indicates the

batteries will need changing.

Recalibration

•Thesmokedetectormightneedrecalibratingafter

time to ensure it is working at its optimum. This is

done by pressing and holding the test button until

the LED ﬂashes and beeps after 10 seconds. The

detector will then start its self calibration routine.

Using your Help Button

Activate an Alarm

•Pressandholdtheredbuttonforatleast3

seconds. The LED will light momentarily and the

alarm will be activated.

Silence an Alarm

•Pressandholddowntheredbuttonfor10

seconds. The LED will light momentarily for a

second time and the alarm will be silenced.

•Pleasenotethatsilencingthealarmwiththehelp

button does not reset the system. If the alarm is

armed prior to activation, the system will re-arm

after being silenced with the help button.

•Thesystemwillrequirearesetatthecontrolunit

after being silenced with the help button.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Commenti su questo manuale

Nessun commento

Yale SmartHome Alarm series Specifiche Pagina 21

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Yale SmartHome Alarm series